Check System Configuration

How to check system information on linux command line

There are several commands on Linux to fetch system information like number of cpus, partitions, their type and hardware information. In this article we will see few commands which are helpful to fetch information like mentioned above.

Command lscpu

The command lscpu will give the brief summary about cpu and cores. That is total number of cpus and number of cores per cpu are available on machine. The command output would be something like below describing cups and cores.

 

Command lspci

Command lspci will list all PCI devices  available and recognized by kernel on machine

This command is useful to find available devices on machine and corresponding vendor.

Command procinfo

This command display system statistics gathered from /proc. That is you will get insight overview from file system /proc

This is command is useful to find,

Users, boot up time, load, swap, memory and interrupt etc.

 

Command lsdev

The command lsdev display information about installed hardware.  This command also gathers some information from /proc file system and will give  quick overview of which hardware uses what I/O addresses, what IRQ and DMA channels

Command lsblk

This is useful to list the block devices available. To list type the following,

lsblk

 

Command lsusb

This command will list all available USB ports on machine.

 

Command lshw

The command lshw will list the complete hardware information. It gives pretty big output. Try this out on your linux box to get complete hardware information,

lshw

Command df -ah

This command displays information regarding partitions something like used space, available space and file system type. To do so type following command

df -ah

Where option -a and -h  are to list  all volumes and display usage in human readable format respectively.

Command mount

The command mount is used for both to display mounted volumes information and mount the required volume at specified location.

To display mounted volumes and location, just type the following command

mount

As mentioned this can also be useful to mount paritions, to do so,

mount /dev/sda2  /location/to/mount

Where /dev/sda2  is the partition to mount at specified location

File /proc/interrupts

The /proc/interrupts contains the list of all supported interrupts by this CPU.  This is nothing more than a file having information about interrupts.

 

Leave a Reply

Your email address will not be published. Required fields are marked *